OpenWorldLab

Loading interactive view…

Interference

Fringes that fade and return

A helium–neon laser’s tube is only 300 mm long, so it can run on two colours at once: two longitudinal modes, 500 MHz apart. Each makes its own fringes in a Michelson interferometer. With the arms equal the two sets agree. Lengthen one arm and they drift apart, until the bright fringes of one fill the dark fringes of the other and the screen goes grey. Lengthen it further and they agree again.

What you are looking at

The laser runs on two longitudinal modes of a 300 mm cavity. Its beam splits at the cube to two flat mirrors 200 mm away, and the returning beams meet on the screen below the cube.

The moving mirror is turned by 300 microradians, so the screen shows straight fringes about a millimetre apart. With the arms equal they are fully dark between the bright ones.

How the bench is set up

Two-mode HeNe laser at 632.8 nm with a 300 mm cavity and a 1.5 mm waist, a 50:50 cube, two flat mirrors 200 mm from it and a screen 300 mm below it.

Select the moving mirror and drag it to the right, or type its position in the inspector: it starts at x = 680 mm.

The theory

Two modes of equal power at frequencies ν\nu and ν+Δν\nu + \Delta\nu make two fringe patterns that add rather than interfere: they beat at 500 MHz, far too fast for a screen to follow. Each millimetre added to one arm adds two to the path difference, so with the arms Δ\Delta apart the fringe visibility is

V=∣cos⁡2π Δν Δc∣=∣cos⁡πΔL∣,Δν=c2L,V = \left|\cos\frac{2\pi\,\Delta\nu\,\Delta}{c}\right| = \left|\cos\frac{\pi\Delta}{L}\right|, \qquad \Delta\nu = \frac{c}{2L},

with LL the laser’s cavity length. The fringes vanish at Δ=L/2\Delta = L/2 = 150 mm and return at Δ=L\Delta = L: every tube length of arm difference. This is the light’s temporal coherence, the Fourier transform of its spectrum (the Wiener–Khinchin theorem). Two lines make a cosine.

What to measure

Fringes vanish at an arm difference of L/2

  1. Move the moving mirror 150 mm further from the cube, to x = 830 mm, and check that the fringes are gone.
  2. Move it to 980 mm, 300 mm further than the fixed arm: the fringes are back, as dark between as with equal arms.
  3. Step either side of 830 mm to find the faintest point: L/2L/2 = 150 mm of arm difference.

What the model leaves out

  • The two modes are equally strong and share one polarisation. In many real HeNe tubes neighbouring modes are polarised at right angles; they make separate fringe patterns all the same, which fade and return in the same way.
  • Each mode is a line 1 MHz wide, so neither loses its own coherence over the table’s lengths.

Things to try

  • Give the laser three modes: the fringes now vanish at a third and two thirds of the tube length, come back faintly (a third as strong) between them, and are full again at a whole one.
  • Give the laser one mode: the fringes stay at any arm difference.
  • Set the cavity length to 0.15 m: the modes are 1 GHz apart and the fringes vanish at 75 mm.

References

  • A. E. Siegman (1986), Lasers, University Science Books.
  • B. E. A. Saleh and M. C. Teich (2019), Fundamentals of Photonics, 3rd edition, Wiley.

More experiments, and how the lab works, are in the laser lab’s overview.