OpenWorldLab

Loading interactive view…

Gravity simulator

The asteroid belt and its Kirkwood gaps

The Solar System on 9 February 1986, as in the Solar System preset, with its belt drawn from 12,000 real asteroids instead of a random sample: numbered asteroids, each on the orbit JPL’s Small-Body Database gives it. Where they are, they fill a broad, thick ring between Mars and Jupiter. Drawn at the sizes of their orbits, they part into rings with gaps between.

Where the gaps are

In 1866 Daniel Kirkwood noticed that few asteroids have orbits of certain sizes: those where an asteroid would go round a whole number of times for a whole number of Jupiter’s orbits. Three for one falls at 2.50 AU, five for two at 2.82, seven for three at 2.95 and two for one at 3.28. There Jupiter’s tugs come at the same points of the asteroid’s orbit time after time and add up instead of averaging out. Over millions of years they make the orbit chaotic and stretch it until it crosses Mars’s or the Earth’s, and the asteroid is cleared out (Wisdom 1983).

The gaps are in the sizes of the orbits, not in where the asteroids are at any moment. Most orbits are a little eccentric, so an asteroid swings in and out across a gap as it goes round, and seen where they are the gaps are smeared out. Show orbit sizes draws each asteroid at its orbit’s size with its eccentricity taken away, and the gaps open as dark rings.

What the catalogue holds

Numbered asteroids are those whose orbits are well measured, and they lean towards the larger ones found earliest, which does not change where the gaps lie. Most of these 12,000 are in the main belt, but a few hundred are not: near-Earth asteroids inside 2 AU, and Trojans sharing Jupiter’s orbit, which on the opening date gather in two loose clouds, ahead of Jupiter and behind it. Their orbits are tilted by up to tens of degrees, so in 3D the belt is a thick ring, not a flat sheet like the planets’ orbits. All of them together, with the millions too small to number, weigh about 3% of the Moon.

How they move

The asteroids are drawn by the graphics card, each moved along its own fixed ellipse round the Sun by Kepler’s laws, so 12,000 cost little. They are not stepped under gravity: Jupiter does not pull on them while the scene runs, and they pull on nothing. Their orbits are the catalogue’s, at one epoch in 2026, carried to whatever date the scene is set; near that epoch they are where the real asteroids are, and decades from it they drift from them. The Sun, planets, moons and comets round them move under Newton’s law, as in the Solar System preset.

What’s on screen

The ideas behind what the scene shows, each with what the simulator does and leaves out, and where to read more.

Spacecraft and gravity assists

A spacecraft changes orbit with short burns, and can borrow speed from a planet.

A spacecraft coasts on an orbit like any other body and changes it with burns. Speeding up at one point of the orbit raises the opposite side; two burns can carry it from one circular orbit to another, as Walter Hohmann worked out in 1925. Fuel is the limit, so missions borrow speed from planets: passing behind a planet as it moves, a craft leaves the planet as fast as it arrived, seen from the planet, but turned, and so gains speed seen from the Sun. Voyager 2 used Jupiter, Saturn and Uranus in turn to reach Neptune in 1989.

In the simulator. Pick a spacecraft and fire burns with the Engine buttons, or W, S, D, A, E and Q. Each is an instant change of speed, and the orbit readout shows at once where it will take you. The Solar System presets start with a probe on Earth’s orbit, 4° ahead of it, ready to fly to another planet.

Read more

Also in Jupiter flyby, Solar System, Solar System, all moons.

The asteroid belt

Millions of rocky bodies between Mars and Jupiter, with gaps where Jupiter’s pull repeats.

Between Mars and Jupiter circle millions of asteroids, though together they weigh only about 3% of the Moon. Jupiter keeps them from ever gathering into a planet. Where an asteroid would go round exactly three times for each of Jupiter’s orbits, or five times for two, Jupiter’s tugs come at the same point of its orbit again and again, and make it chaotic until it is thrown out: these are the Kirkwood gaps, found in 1866.

In the simulator. The Asteroid belt preset shows 12,000 numbered asteroids on their catalogued orbits, and Show orbit sizes draws each at its orbit’s size, where the Kirkwood gaps open as rings. The Solar System presets draw the belt as 1,500 grains set at random between 2.2 and 3.2 AU instead. The catalogued asteroids follow fixed Kepler orbits round the Sun; the grains feel the Sun and planets but pull on nothing.

Read more

Also in Solar System, Solar System, all moons.

Places to visit

Zoom out of any scene to reach the galaxy it lives in and the cosmic web beyond it, or go straight there.

Things to try

  • Open View and, under Asteroid belts and Trojan swarms, press Show orbit sizes: the belt parts into rings, with clear gaps at 2.50 and 3.28 AU and narrower ones between.
  • Turn on 3D and press Edge-on: the belt is far thicker than the plane of the planets’ orbits.
  • Zoom out until Jupiter is on the screen: two loose clouds of asteroids share its orbit, ahead of it and behind it. These are the Trojans.
  • Click the date at the bottom left and set it to now: the planets and the asteroids move to where they are today.

More scenarios