Induction and circuits
Resonance in an RLC circuit
Drive a resistor, a coil and a capacitor in series with an AC source and the current depends sharply on the frequency. At one frequency the coil and capacitor cancel each other and only the resistance limits the current: resonance.
Before you look
Predict first: At resonance, 1.59 kHz, how big is the current from the 1 V source?
What you are looking at
An AC source, 10 Ω, a 10 mH inductor and a 1 µF capacitor in a loop, with an ammeter. The clock runs a thousand times slow.
Change the source’s frequency in the inspector and let the current settle; read its peak on the ammeter.
The physics
The impedance of the series circuit is , so the current amplitude is
It peaks at , 1.59 kHz here. The sharpness of the peak is the quality factor
and the curve’s width between the half-power points is , 159 Hz.
Going deeper
Vector calculus and Maxwell’s equations
At resonance the voltage across the coil, and across the capacitor, is Q times the source’s: 10 V each from a 1 V source, in opposite directions. Energy sloshes between them as in the LC circuit; the source only tops up what the resistor takes.
What to measure
Current amplitude V/√(R² + (ωL − 1/ωC)²)
- At 1592 Hz the ammeter should peak at 0.100 A.
- At 0.8 f₀ (1273 Hz) and at 1.25 f₀ (1990 Hz) it falls to about 0.022 A.
- Find the two frequencies where the current is 0.071 A (1/√2 of the peak): they are about 159 Hz apart.
What the model leaves out
- Wires are perfect conductors with no inductance of their own, and nothing radiates: the circuit is lumped, which is right while it is much smaller than a wavelength.
- The parts are ideal symbols: the inductor has no resistance and the capacitor no leakage.
Things to try
- Raise the resistance to 100 Ω: Q drops to 1 and the peak almost disappears.
- Try a square wave at f₀/3: its third harmonic is at resonance, and the current is nearly a sine at f₀.
References
- P. Horowitz and W. Hill (2015), The Art of Electronics, 3rd edition, Cambridge University Press.
- D. J. Griffiths (2017), Introduction to Electrodynamics, 4th edition, Cambridge University Press.
- E. M. Purcell and D. J. Morin (2013), Electricity and Magnetism, 3rd edition, Cambridge University Press.
More experiments, and how the lab works, are in the lab’s overview.
