Induction and circuits
Mutual inductance
Two coils near each other share some flux. The mutual inductance M says how much: the flux through one per ampere in the other. It depends only on their shapes and where they are, and it is the same whichever coil carries the current.
Before you look
Predict first: You turn the second coil side-on, its axis across the first coil’s. What is M now?
What you are looking at
Two 100-turn coils 10 cm apart on one axis. The left one carries 1 kHz AC, with an ammeter in its circuit; the right one feeds a voltmeter.
Drag the right coil about while the clock runs, and turn it with R or [ ]. Its leads follow it.
The physics
An AC current in the first coil induces in the second, so the meters measure M directly. Neumann’s formula gives M from the shapes alone:
Far apart, each coil looks like a magnetic dipole to the other, and on their common axis
Double the distance and M falls eight times; turn the second coil by θ and only cos θ of the flux goes through it.
Going deeper
Vector calculus and Maxwell’s equations
Neumann’s formula is symmetric in the two coils, so : the flux through coil 2 per ampere in coil 1 always equals the flux through coil 1 per ampere in coil 2, however different the coils. For coaxial circles Maxwell evaluated the double integral in elliptic integrals in 1873, and the lab uses his formula.
What to measure
M = V₂/ωI₁; M ∝ cos θ/d³ far away
- Read the ammeter and voltmeter peaks and work out M = V₂/(ωI₁); the coil’s pill gives the same.
- Drag the coil to 20 cm, then 40 cm: M should fall by about eight each time you double the distance.
- Turn the coil to 60°: M halves.
What the model leaves out
- Coils, rings and magnets are filament loops, each standing for a bundle of turns or a slice of a magnet’s surface current. Very close to a loop the field is a little lumpy; a few loop spacings away it is exact.
- Wires are perfect conductors with no inductance of their own, and nothing radiates: the circuit is lumped, which is right while it is much smaller than a wavelength.
- The voltmeter draws no current, so the second coil does not act back on the first.
Things to try
- Move the coil off the axis, beside the first one: M changes sign, because there the field runs back the other way.
- Give the second coil more turns: M grows in proportion.
References
- F. W. Grover (1946), Inductance Calculations, Van Nostrand; reprinted by Dover.
- D. J. Griffiths (2017), Introduction to Electrodynamics, 4th edition, Cambridge University Press.
- E. M. Purcell and D. J. Morin (2013), Electricity and Magnetism, 3rd edition, Cambridge University Press.
More experiments, and how the lab works, are in the lab’s overview.
