OpenWorldLab

Loading interactive view…

Capacitors and dielectrics

A dielectric slab

An insulator between the plates of a capacitor lets it hold more charge at the same voltage. Its molecules stretch in the field, and the ends of the stretched molecules leave bound charge on the slab’s faces, opposite to the plates’. That weakens the field inside, so the plates take on more charge to keep their voltage.

Before you look

Predict first: Held at a fixed voltage, is the slab pulled into the gap, pushed out, or neither?

What you are looking at

Plates 40 cm wide and 4 cm apart at ±50 V, with a slab of relative permittivity ε_r = 4 halfway in.

The physics

C=ε0wd[x εr+(w−x)]1w  →  εrC0 when fullC = \frac{\varepsilon_0 w}{d}\bigl[x\,\varepsilon_r + (w - x)\bigr]\frac{1}{w} \;\to\; \varepsilon_r C_0 \text{ when full}

xx is how far the slab reaches into the gap and ww the plates’ width. The fringing field outside the slab stays in air, so the measured ratio is a little below εr\varepsilon_r.

Going deeper

Vector calculus and Maxwell’s equations

At fixed charge instead of fixed voltage, the slab lowers the voltage by εr\varepsilon_r and the stored energy falls: either way it is pulled in.

What to measure

C rises by ε_r where the slab fills the gap

  1. The check compares the capacitance with the slab fully in and fully out.

What the model leaves out

  • Friction and the slab’s mass: the force is shown, not the motion.

Things to try

  • Drag the slab in and out and watch the glow between the plates dim where it is.

References

  • D. J. Griffiths (2017), Introduction to Electrodynamics, 4th edition, Cambridge University Press.
  • E. M. Purcell and D. J. Morin (2013), Electricity and Magnetism, 3rd edition, Cambridge University Press.

More experiments, and how the lab works, are in the lab’s overview.