OpenWorldLab

Loading interactive view…

Induction and circuits

Faraday’s law: a magnet and a coil

In 1831 Michael Faraday found that a magnet makes a current only while it moves. Push a magnet into a coil and a meter on the coil kicks one way; hold it still and the meter returns to zero; pull it out and it kicks the other way.

Before you look

Predict first: You push the magnet into the coil twice as fast. What happens to the total charge that flows round the circuit?

What you are looking at

A 200-turn coil wired to a galvanometer, a sensitive centre-zero meter whose needle swings with some inertia. The magnet on the left is a neodymium bar 3 cm long, north end red.

Drag the magnet into the coil. The coil glows while current flows and the dots run round the circuit; ⊙ and ⊗ show which way the current goes round the turns. Pull it out again and everything reverses.

The magnet follows your pointer on a stiff spring. With a closed circuit the current pushes back on it a little: Lenz’s law, which the next experiment makes stronger.

The physics

Faraday’s law: the EMF round a circuit is minus the rate of change of the magnetic flux linking it,

E=−dΦdt,Φ=N∫B⋅dA\mathcal E = -\frac{d\Phi}{dt}, \qquad \Phi = N\int \mathbf B\cdot d\mathbf A

With the circuit’s resistance R (coil and meter, 22 Ω here) and its inductance L, E=IR+L dI/dt\mathcal E = IR + L\,dI/dt. Integrated over a push that starts and ends at rest, the L dI/dtL\,dI/dt term adds up to nothing, so the charge through the meter is

Q=∫I dt=−ΔΦRQ = \int I\,dt = -\frac{\Delta\Phi}{R}

Pushing the magnet to the coil’s middle links about 15 mWb-turns, so about 0.67 mC flows, whatever the speed.

Going deeper

Vector calculus and Maxwell’s equations

In differential form Faraday’s law is ∇×E=−∂B/∂t\nabla\times\mathbf E = -\partial\mathbf B/\partial t: a changing magnetic field makes an electric field that circulates, with no charges anywhere. The EMF is ∮E⋅dl\oint\mathbf E\cdot d\mathbf l round the wire. For a moving magnet and a still coil, the field the coil’s electrons feel is this induced E\mathbf E; seen from the magnet, it is qv×Bq\mathbf v\times\mathbf B on electrons moving past. Einstein started special relativity from that symmetry.

What to measure

Charge through the meter = ΔΦ/R; EMF = −dΦ/dt

  1. Push the magnet into the coil and stop: read the charge through the meter in the inspector.
  2. Pull it out to where it started: the same charge flows back, with the opposite sign.
  3. Do it again faster: the needle swings further, but the charge is the same.

What the model leaves out

  • Coils, rings and magnets are filament loops, each standing for a bundle of turns or a slice of a magnet’s surface current. Very close to a loop the field is a little lumpy; a few loop spacings away it is exact.
  • The magnet is rigid and ideal: its magnetisation never changes.
  • Wires are perfect conductors with no inductance of their own, and nothing radiates: the circuit is lumped, which is right while it is much smaller than a wavelength.

Things to try

  • Turn the magnet round (R) so its south pole leads: the needle swings the other way.
  • Set the magnet’s motion to “Pushed in and out” and watch the meter follow.
  • Delete a wire so the circuit is open: the needle stays still, but the coil’s EMF pill still reads.

References

  • M. Faraday (1832), Experimental Researches in Electricity, Philosophical Transactions of the Royal Society 122, 125.
  • D. J. Griffiths (2017), Introduction to Electrodynamics, 4th edition, Cambridge University Press.
  • E. M. Purcell and D. J. Morin (2013), Electricity and Magnetism, 3rd edition, Cambridge University Press.
  • R. P. Feynman, R. B. Leighton and M. Sands, The Feynman Lectures on Physics, Volume II.

More experiments, and how the lab works, are in the lab’s overview.