OpenWorldLab

Loading interactive view…

Potential and conductors

A conductor in a field

Metal is full of electrons free to move. Put it in a field and they drift until they stop feeling any push, which happens only when the field inside is zero. The charge that moves sits on the surface: negative where the field comes in, positive where it leaves. Outside, field lines meet the surface square on.

Before you look

Predict first: The rod is uncharged. What is the total charge on its surface?

What you are looking at

A metal rod 20 cm across, seen end-on in the extruded world, in a uniform field of 1000 V/m pointing right. Glow shows field strength; dashed lines are equipotentials; ± marks show induced charge.

The physics

Er(r,θ)=E0cos⁡θ(1+a2r2),σ=2ε0E0cos⁡θE_r(r,\theta) = E_0\cos\theta\left(1 + \frac{a^2}{r^2}\right), \qquad \sigma = 2\varepsilon_0E_0\cos\theta

At the surface (r=ar = a) the field is 2E0cos⁡θ2E_0\cos\theta, all of it normal to the metal.

Going deeper

Vector calculus and Maxwell’s equations

The surface is an equipotential, so the equipotentials just outside wrap round it and the field lines arrive at right angles.

What to measure

E = 0 inside; 2E₀ at the poles

  1. The check reads the field inside (zero) and just outside, facing the field (twice the applied field).

What the model leaves out

  • How long the electrons take to settle: in copper about 10⁻¹⁹ s.

Things to try

  • Charge the rod in the inspector: the extra charge spreads over the surface and the field inside stays zero.
  • Change it to a block and watch charge gather at the corners.

References

  • D. J. Griffiths (2017), Introduction to Electrodynamics, 4th edition, Cambridge University Press.
  • E. M. Purcell and D. J. Morin (2013), Electricity and Magnetism, 3rd edition, Cambridge University Press.

More experiments, and how the lab works, are in the lab’s overview.